VLAN Questions 2
Question 1 Question 2 Question 3 Explanation The default Ethernet VLAN is VLAN 1. It is a security best practice to configure all the ports on all switches to be associated with VLANs other than VLAN...
View ArticleVLAN Questions
Note: If you are not sure about Virtual Local Area Network (VLAN), please read our Virtual Local Area Network VLAN Tutorial. Question 1 Question 2 Question 3 Question 4 Question 5 Explanation On an...
View ArticleSwitch Questions 2
Question 1 Explanation When you connect an IP phone to a switch using a trunk link, it can cause high CPU utilization in the switches. As all the VLANs for a particular interface are trunked to the...
View ArticleSwitch Questions
Question 1 Explanation In cut-through switching, the switch copies into its memory only the destination MAC address (first six bytes of the frame) of the frame. After processing these first six bytes,...
View ArticleIP Address Questions
Question 1 Explanation IP multicast is a bandwidth-conserving technology that reduces traffic by simultaneously delivering a single stream of information to potentially thousands of corporate...
View ArticleCDP & LLDP Questions
Question 1 Explanation CDP is enabled by default on all Cisco routers. If it is turned off by any reason, we can turn it on again with the following command on global configuration mode:...
View ArticleDMVPN Questions
If you are not sure about DMVPN, please read our DMVPN tutorial (on digitaltut.com). Question 1 Explanation The topology of DMVPN is always hub-and-spoke as all Spokes are required to connect to the...
View ArticleMPLS Questions
Note: If you are not sure about OSI Model, please read our MPLS tutorial. Question 1 Explanation MPLS operates at a layer that lies between traditional definitions of Layer 2 (data link layer) and...
View ArticlePPPoE Questions
If you are not sure about PPPoE, please read our PPPoE tutorial (on digitaltut.com). Question 1 Explanation The picture below shows all configuration needed for PPPoE: There is no Dialer interface on...
View ArticleQoS Questions
Question 1 Explanation The following diagram illustrates the key difference between traffic policing and traffic shaping. Traffic policing propagates bursts. When the traffic rate reaches the...
View ArticlePPP Questions
Question 1 Question 2 Question 3 Explanation Both routers must use the same password for CHAP to authentication. Question 4 Explanation Point-to-point leased line is the most expensive interconnection...
View ArticleWAN Questions
If you are not sure about WAN, please read our WAN tutorial. Question 1 Explanation An example of the output of the “show interface serial …” command is shown below. We can see the line “Encapsulation...
View ArticleCloud & Virtual Services
Question 1 Question 2 Explanation Network virtualization architecture has three main components: + Network access control and segmentation of classes of users: Users are authenticated and either...
View ArticleOSI TCP/IP Model Questions
Note: If you are not sure about OSI Model, please read our OSI Model tutorial. Question 1 Explanation The transport layer segments data into smaller pieces for transport. Each segment is assigned a...
View ArticleBasic Questions 2
Question 1 Explanation MDI stands for “Medium Dependent Interface”. MDI is a type of Ethernet port found on network devices. When connecting two devices with MDI ports (two hosts, for example) an...
View ArticleBasic Questions
Question 1 Explanation Star topology is the most popular topology for the network which allows all traffic to flow through a central device. Question 2 Explanation Carrier sense multiple access with...
View ArticlePrivacy-Policy
All of the articles on 9tut.com are copyright its respective owner. You are allowed to use them anywhere with a link back to its original article on this site.
View ArticleVLAN Troubleshooting Sim
Refer to the exhibit. Your colleague has built a Layer 2 network in your client locations. You must verify the configuration and fix any issues identified as per customer requirements. Customer...
View ArticleBasic MPLS Tutorial
MPLS is a new forwarding mechanism called “label switching” in which packets are forwarded based on labels. However, hosts are unaware about labeled packets so routers will need to add a label when...
View ArticleEIGRP GRE Troubleshooting Sim
Refer to the topology below. Your company asks you to identify the issues in Phase 1 EIGRP implementation. You have console access on R1, R2, R3 Branch1 and Branch2 routers. Only use show commands to...
View Article